Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

Failsafe setting „Failsafe“
The remote control has the option of automatically moving the servos to a specific position at impairment of the

reception signal. This way, the drive motor can be switched off, e.g. in an electrical gliding model that is outside of the 

transmitter range, and circling can be started.
Proceed as follows to set the fail safe values for all six control channels:
•  Call the „RX Setup“ menu.
•  Use the buttons „UP“ or „DOWN“ to select the menu item „Fail-

safe“ and activate it with the button „OK“. Channel 1 is already 

selected and can be set.

•  Briefly push the button „OK“ to call the set values for channel

1. The current activation condition for channel 1 is displayed.

•  Use the buttons „UP“ or „DOWN“ to switch the activation con-

dition from „OFF“ to „ON“ or vice versa. 

•  If the function is switched on, move the control stick for chan-

nel  1  to  the  desired  failsafe  position  and  push  the  button 

„CANCEL“ a little longer. 

•  The display switches back to the channel overview and dis-

plays the percentage set value for channel 1. 

  If you keep the button „OK“ pushed, the factory setting 

is called and the fail safe function is switched off for all 

six channels.

•  You  can  now  use  the  buttons  „UP“  and  „DOWN“  to  select

further channels and set them according to the same princip-

le.

•  When you have set the desired value for all channels, push

the button „CANCEL“ until you return to the operating display.

•  Switch the transmitter off for test purposes and check if all

servos move to the fail safe position desired by you