Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

Using the servo end deflection setting you can precisely define the maximum size of servo travel that is permitted on

each side. The servo end deflection function is typically used to protect servos from mechanically hitting an obstacle

when deflecting to the full extent. You can set a value from 0 to 120%. The smaller the value, the shorter the servo

travel.

  Always try to select the linkage points on the servo and the rudder sticks so that they reach maximum rudder 

deflections at the factory preset value of 100%.

 

The linked rods or sticks should not hit anything or be under any mechanical tension. This ensures that this 

function is only required to make minimal adjustments. The rudder travel values given in the model operating 

instructions which may be less than the maximum possible rudder travel values can be reduced later on with 

the dual rate function.

Setting the servo end deflection:
•  Switch on the transmitter and call the function setting menu.
•  Move the cursor arrow to the menu item „End points“ with the

two buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  In the display you will see display items for the six control func-

tions with the currently set servo end deflections.

•  Move the control stick for channel 1 all the way to the left and

then adjust the maximum possible servo deflection of the left

side with the buttons „UP“ and „DOWN“.

•  Then move the control stick for channel 1 all the way to the

right and then adjust the maximum possible servo deflection of

the right side with the buttons „UP“ and „DOWN“. If the button 

„OK“ is pushed and held, the factory parameters are called.

•  When pushing the button „OK“ briefly, the cursor arrow will

jump to channel 2. The servo deflection of channel 2 is set by

the same principle as in channel 1.

•  Repeat his process until you have set the correct servo end

deflections in all six channels.

•  Keep the button „CANCEL“ pushed for a longer period to save

the settings. The display then shows the function setup menu 

again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.