Справочник Пользователя для Reely Hendheld RC 2.4 GHz No. of channels: 6 1310037

In this menu you can graphically display the servo control settings for all 6 channels and simultaneously check the 

individual control functions with all mixers. Especially with helicopter models you can easily very quickly make mixer 

errors for swash plate control. The servos can be tested as well in this programme. For this, all six channels are 

automatically run from one end stop to the other and back. 
Display servo control:
•  Switch on the transmitter and call the function setting menu.
•  Move the cursor arrow to the menu item „Display“ with the two

buttons „UP“ and „DOWN“.

•  Briefly push the button „OK“ to activate the menu item.
  The display shows the 6 channels in the current position of the 

encoders.

  If you move the control sticks, activated switches or rotating 

encoders  in  different  directions  now,  you  will  see  precisely 

which servo is controlled in which direction.

•  Push and hold the button „CANCEL“ to start the servo test.

The six bar displays now continually run from one end stop to 

the other. With the receiver activated, the servos react accor-

ding to the bar charts.

•  Push the button „OK“ to terminate the servo test. The display

then shows the function setup menu again.

•  Push the button „CANCEL“ repeatedly until you get back to

the operating display.