Техническая Спецификация для Superrollo Professional TA50 Garage Door Motor 50kg SR40050

Модели

SR40050

Move the door carefully, in order to engage

the profile slide.
Plug the mains plug into the socket and

switch on the electricity.
The light goes on and the unit gives a single

beep and the display shows ‘0’ at regular

intervals.

Attach safety notices with warning messages

Establish operational readiness of the door

Programming

In order that the following settings are cor-

rectly stored and executed, you must carry

out a final programming procedure according

to page 59.

Improper use results in an increased risk of

injury.
◆

Permanently fix the labels warning against entrapment

in a prominent place or near any fixed controls.
◆

Permanently fix the label concerning the manual release

adjacent to its actuating member.
◆

Attach all labels so that they are clearly legible.

Important notes after installation

◆

After installation, ensure that the mechanism is properly

adjusted and that the drive reverses when the door

contacts a 50 mm high object placed on the floor

(for drives incorporating an entrapment protection

system depending on contact with the bottom edge of

the door), s. page 64.

◆

After installation, ensure that the drive prevents or stops

the opening movement when the door is loaded with

a mass of 20 kg, fixed centrally on the bottom edge

of the door. This applies especially to drives which can

be used with a door that has openings in the door leaf

larger than 50 mm in diameter.