Superrollo Professional TA50 Garage Door Motor 50kg SR40050 数据表
产品代码
SR40050
52
EN
Move the door carefully, in order to engage
the profile slide.
Plug the mains plug into the socket and
Plug the mains plug into the socket and
switch on the electricity.
The light goes on and the unit gives a single
The light goes on and the unit gives a single
beep and the display shows ‘0’ at regular
intervals.
Attach safety notices with warning messages
1.
2.
3.
Establish operational readiness of the door
Programming
In order that the following settings are cor-
rectly stored and executed, you must carry
out a final programming procedure according
to page 59.
Improper use results in an increased risk of
injury.
◆
◆
Permanently fix the labels warning against entrapment
in a prominent place or near any fixed controls.
◆
◆
Permanently fix the label concerning the manual release
adjacent to its actuating member.
◆
◆
Attach all labels so that they are clearly legible.
Important notes after installation
◆
After installation, ensure that the mechanism is properly
adjusted and that the drive reverses when the door
contacts a 50 mm high object placed on the floor
(for drives incorporating an entrapment protection
system depending on contact with the bottom edge of
the door), s. page 64.
◆
After installation, ensure that the drive prevents or stops
the opening movement when the door is loaded with
a mass of 20 kg, fixed centrally on the bottom edge
of the door. This applies especially to drives which can
be used with a door that has openings in the door leaf
larger than 50 mm in diameter.