Справочник Пользователя для Kathrein UFS 924sw/500GB/CI+ 20210209
Модели
20210209
8
Product return/original packaging
Make sure that the fan at the rear of the unit and the ventilation slots on the unit are
not blocked or covered in any way. The unit may otherwise overheat. Adjust the fan
speed to the temperature conditions in the receiver.
not blocked or covered in any way. The unit may otherwise overheat. Adjust the fan
speed to the temperature conditions in the receiver.
There is a risk of fi re!
You must not disconnect the receiver from the mains while it is in operation!
This can lead to a loss of data and corruption of the software.
This can lead to a loss of data and corruption of the software.
Safety instructions - important notes
Please keep the original packaging in case you need to return the product at any time. The receivers are
fragile due to their construction and are only adequately protected by the original packaging. If the receiver
is not shipped correctly the guarantee/warranty on it will be voided.
Before you disconnect the receiver from the mains, you must switch it to the standby mode by pressing the
standby button (on/off) on the remote control. In standby mode, any changed or new data that are broadcast
will be saved by the receiver. As soon as the receiver is in the standby mode, it can be disconnected from
the mains at any time.
Instructions on how to set the fan can be found in the section “Mainmenu”, “Settings”, “Basic Settings”,
“Fan Control”.
Fan/ventilation slots on the unit
Switching the receiver off
Warning!
Channel assignment
The channels available on the satellites and transponders are subject to continual change. In such cases,
it is necessary to reset the channels as the factory preset programming corresponds to the situation on
the date of manufacture. The information for these settings can be found on the Internet or in relevant
magazines.
If the receiver's remote control is not operated for four hours the receiver automatically switches to standby
mode. Before the receiver enters standby mode you get a message that you can stop this by pressing
any button on the remote control. You can deactivate this function by selecting “Mainmenu - Settings”,
“Userdef ned”, “Customize Screen Menu”.
Automatic standby of the receiver after 4 hours