Техническая Спецификация для Renkforce 808576 Wireless Surveillance System 808576
Модели
808576
55
Function „Pairing“
Each radio camera must be logged on to the screen/DVR; otherwise, reception of the AV signal of the radio
Each radio camera must be logged on to the screen/DVR; otherwise, reception of the AV signal of the radio
camera is not possible.
This login process is also called „Pairing“.
This login process is also called „Pairing“.
Each radio camera can be logged on to only one screen/DVR for reasons of safety. It also is not
possible to play back the AV signal of a radio camera on two screens/DVRs.
Only one radio camera can be logged on to each channel of the screen/DVR. If a radio camera
has already been registered at a channel, a new registration of a new radio camera will overwri-
te the present one.
Since only 10 seconds are available for logging on for reasons of safety, the screen/DVR and radio came-
ra should be in direct proximity to each other. Alternatively, the login process must be performed with a
second person.
Proceed as follows:
• Use the buttons „4“ and „6“ to pick the function „Pairing“ and then push „
Proceed as follows:
• Use the buttons „4“ and „6“ to pick the function „Pairing“ and then push „
“.
• Use the buttons „4“ and „6“ to pick one of the four channels now.
• Push the button „
• Push the button „
“ and a time display appears, counting down from 10 to 0.
Within these 10 seconds, the square button in the housing (19) in the radio camera‘s cable must be pu-
shed briefly (about 1 second).
If the radio camera was recognised properly, „Pair Success“ (= pairing process successful) appears in
the display of the screen/DVR and then the camera screen.
If the radio camera is not found (e.g. out of range or the button is not pushed within 10 seconds), „Pair
Fail“ appears (= pairing failed).
• If pairing failed, restart it (select one of the four channels with „8“ and „2“ and push the button
„
“).
• To cancel pairing, push the button „MENU“ repeatedly to return to the respective previous menu or to
leave the OSD menu.
Function „Quality“
Here, you can set the resolution (VGA = 640 x 480 or QVGA = 320 x 240 pixels) in which the recordings on
Here, you can set the resolution (VGA = 640 x 480 or QVGA = 320 x 240 pixels) in which the recordings on
the memory card are to take place.
Proceed as follows:
• Use the buttons „4“ and „6“ to pick the function „Quality“ and then push „
Proceed as follows:
• Use the buttons „4“ and „6“ to pick the function „Quality“ and then push „
“.
• Use the buttons „4“ and „6“ to switch between „VGA“ (= 640 x 480 pixels) and „QVGA“ (= 320 xx 240
pixels).
• Confirm the setting with „
“.
• If required, push the button „MENU“ repeatedly to return to the respective previous menu or to leave the
OSD menu.