Renkforce 808576 Wireless Surveillance System 808576 Scheda Tecnica

Function „Pairing“
Each radio camera must be logged on to the screen/DVR; otherwise, reception of the AV signal of the radio

camera is not possible.
This login process is also called „Pairing“.

  Each radio camera can be logged on to only one screen/DVR for reasons of safety. It also is not 

possible to play back the AV signal of a radio camera on two screens/DVRs.

 

Only one radio camera can be logged on to each channel of the screen/DVR. If a radio camera 

has already been registered at a channel, a new registration of a new radio camera will overwri-

te the present one. 

Since only 10 seconds are available for logging on for reasons of safety, the screen/DVR and radio came-

ra should be in direct proximity to each other. Alternatively, the login process must be performed with a 

second person.
Proceed as follows:
•  Use the buttons „4“ and „6“ to pick the function „Pairing“ and then push „

“. 

•  Use the buttons „4“ and „6“ to pick one of the four channels now.
•  Push the button „

“ and a time display appears, counting down from 10 to 0. 

 Within these 10 seconds, the square button in the housing (19) in the radio camera‘s cable must be pu-

shed briefly (about 1 second).

  If the radio camera was recognised properly, „Pair Success“ (= pairing process successful) appears in 

the display of the screen/DVR and then the camera screen.

  If the radio camera is not found (e.g. out of range or the button is not pushed within 10 seconds), „Pair 

Fail“ appears (= pairing failed).

•  If  pairing  failed,  restart  it  (select  one  of  the  four  channels  with  „8“  and  „2“  and  push  the  button  

„

“).

•  To cancel pairing, push the button „MENU“ repeatedly to return to the respective previous menu or to

leave the OSD menu.

Function „Quality“
Here, you can set the resolution (VGA = 640 x 480 or QVGA = 320 x 240 pixels) in which the recordings on 

the memory card are to take place.
Proceed as follows:
•  Use the buttons „4“ and „6“ to pick the function „Quality“ and then push „

“. 

•  Use the buttons „4“ and „6“ to switch between „VGA“ (= 640 x 480 pixels) and „QVGA“ (= 320 xx 240 

pixels).

•  Confirm the setting with „

“.

•  If required, push the button „MENU“ repeatedly to return to the respective previous menu or to leave the

OSD menu.