Справочник Пользователя для Inline Warehouse IN60000
5
1995-1997 - INLINE, INC
PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
S
AVING
AND
R
ECALLING
S
ETUP
M
EMORIES
The PATHFINDER can store and recall up to 8 setup memories. A memory stores input to output
connection information, and when recalled, executes all of the switch connections.
connection information, and when recalled, executes all of the switch connections.
When the PATHFINDER is turned on, it uses setup #1 as the default, and this cannot
be changed. If you plan on turning off the PATHFINDER, make certain to store the
initial settings in Setup #1.
be changed. If you plan on turning off the PATHFINDER, make certain to store the
initial settings in Setup #1.
Saving a Setup Memory:
To save a memory configuration, make the desired input to output connections for all groups and then push
the SAVE/RECALL button. The following screen will appear (Note: Changes must be made in order for
the PATHFINDER to prompt you if you would like to Save the changes):
the SAVE/RECALL button. The following screen will appear (Note: Changes must be made in order for
the PATHFINDER to prompt you if you would like to Save the changes):
You have three options to choose from, with
S
b showing the current Setup being used. Press the
appropriate number button as follows:
1)Y
:
Pressing the number 1 button saves the input to output connection information to Setup #b.
2)N
:
Pressing the number 2 button tells the PATHFINDER that you do not want to save the changes. As
the SAVE/RECALL button is a single button for two functions (Save and Recall), the unit enters the
Recall menu to allow you to recall a Setup memory (see Recalling a Setup Memory on page 6 for
more details).
the SAVE/RECALL button is a single button for two functions (Save and Recall), the unit enters the
Recall menu to allow you to recall a Setup memory (see Recalling a Setup Memory on page 6 for
more details).
3)SETUP#
:
Pressing the number 3 button allows you to save the input to output connection information to any
Setup memory. The following screen will appear:
Setup memory. The following screen will appear:
The flashing cursor over
Setup:
b shows that you can change this with the number buttons. Press
the number button of the Setup# you would like to store this information to. Confirm this selection
by pressing the ENTER/SELECT button.
by pressing the ENTER/SELECT button.