Справочник Пользователя для Inline Warehouse IN60000
10
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
LCD Contrast Adjust:
The LCD Contrast Adj. section allows you to adjust the contrast of the PATHFINDER’s front panel LCD
screen. Press the ENTER/SELECT button when the screen reads as follows:
screen. Press the ENTER/SELECT button when the screen reads as follows:
The following screen will appear:
The UP Scroll button will increase the contrast while the DOWN Scroll button will decrease the contrast.
When you have set the LCD screen to the desired contrast level, press the MENU, ENTER/SELECT or
SAVE/RECALL button as follows:
When you have set the LCD screen to the desired contrast level, press the MENU, ENTER/SELECT or
SAVE/RECALL button as follows:
MENU or ENTER/SELECT:
Pressing the MENU or ENTER/SELECT button will temporarily store the LCD Contrast setting
until the power is turned off. Upon re-applying power to the PATHFINDER, the LCD Contrast
setting will return to its previously saved setting.
Pressing the MENU or ENTER/SELECT button will temporarily store the LCD Contrast setting
until the power is turned off. Upon re-applying power to the PATHFINDER, the LCD Contrast
setting will return to its previously saved setting.
SAVE/RECALL:
Pressing the SAVE/RECALL button will save the LCD Contrast setting in memory and will use it
every time the unit is powered on. This setting will remain until you re-program the unit to Save a
different setting or reset the PATHFINDER to Factory Default (see Power On Settings on page 13
for more details).
Pressing the SAVE/RECALL button will save the LCD Contrast setting in memory and will use it
every time the unit is powered on. This setting will remain until you re-program the unit to Save a
different setting or reset the PATHFINDER to Factory Default (see Power On Settings on page 13
for more details).
RS-232 BAUD Rate:
The RS-232 BAUD Rate section allows you to choose the baud rate at which the PATHFINDER’s remote
control port operates at. If you are not using a remote control device, such as a PC or a third party remote
control system, you can ignore this section. However, if you are controlling the PATHFINDER remotely,
you may need to change the baud rate to match that of the control device. The factory default setting is
1200 baud, and you can change this to 2400, 4800, 9600 or 19200 baud as required. Enter this section by
pressing the ENTER/SELECT button when the screen reads as follows:
control port operates at. If you are not using a remote control device, such as a PC or a third party remote
control system, you can ignore this section. However, if you are controlling the PATHFINDER remotely,
you may need to change the baud rate to match that of the control device. The factory default setting is
1200 baud, and you can change this to 2400, 4800, 9600 or 19200 baud as required. Enter this section by
pressing the ENTER/SELECT button when the screen reads as follows: