Справочник Пользователя для Greyhound Lines 39981

Step 5)  

Repeat Step 4 to advance the Piston Rod (A-32) forward.  This will push the log

 

 

against the Wedge and split the log.  

Step 6)  

Once the Log is split, remove the pieces from the Log Splitter.  Turn the Release    

 

 

 

Screw  counterclockwise so that the Piston retracts back into the Cylinder as in

 

 

Step 2 (see Figure 2).  Tighten the Release Screw once the Piston Rod is fully    

 

 

 

retracted.  

Step 7)  

Continue the preceding steps until all logs have been split.  Once completed,  

 

 

 

 

your Log Splitter should be stored with the Release Screw (A-49) opened so

 

 

that any hydraulic pressure is relieved during non-use.

After every use, wipe down the Log Splitter to remove any tree sap or dirt occurring during use.  This will 
extend the use of the Log Splitter.

Step 1)  

Operate the Log Splitter so that the Piston Rod (A-32) is extended to its maximum length.  

Step 2)  

Remove the Oil Filling Plug (A-56) as shown in Figure 4.

Step 3)  

Turn the Release Screw (A-44) counterclockwise as fast as possible.  The  

 

 

 

 

Piston Rod will retract into the Cylinder and push air out of the Oil Filling Hole.  

Step 4)  

Replace the Oil Filling Plug.  Repeat steps one (1) through four (4) as necessary.

Step 1)  

The Log Splitter uses Hydraulic oil.  If you need to add oil to the Log Splitter,  

 

 

 

 

remove the Oil Filling Plug and add oil until the Log Splitter is 3/4 full.