Справочник Пользователя для Brother DH4-B980
10. SUMMARY OF DIP SWITCHES
RH-9800
57
10-2. Circuit board DIP switches
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
The ON/OFF positions of the DIP switches inside the front panel are checked only once when the power is turned on.
Any changes to the DIP switch positions will not be effective until the power is switched off and back on again.
Only one of DIP switch No.1, 2 and 3 is effective at any one time. They are effective in the order 1, 2, 3.
Any changes to the DIP switch positions will not be effective until the power is switched off and back on again.
Only one of DIP switch No.1, 2 and 3 is effective at any one time. They are effective in the order 1, 2, 3.
No.
ON/OFF
Description
ON
Data initialization
1
OFF
Normal
ON
Input check
2
OFF
Normal
ON
Output check
3
OFF
Normal
ON
Upper gimp guide present
4
*1
OFF
Upper gimp guide not present
ON
Upper thread nipper present
5
*2
OFF
Upper thread nipper not present
ON
Upper and lower thread trimming
6
OFF
Upper thread trimming
ON
Material is remains pressed after sewing
7
OFF
Material is released after sewing
ON
Needle bar returns to home position after set number of pieces sewn
8
OFF
Needle bar always returns to home position after each piece sewn
*1
The version of the PROM is given as “E1” or later.
*2
The version of the PROM is given as “D1” or later.
If the stitch length has been set to 39 mm or greater, it will be automatically changed to 38 mm if DIP switch No. 6 is
changed to ON.
* The machine is shipped from the factory with the DIP switches set as follows.
changed to ON.
* The machine is shipped from the factory with the DIP switches set as follows.
1193Q