Справочник Пользователя для Brother 882-W07

338

In order to prevent damaging this machine, it must 
not be oiled by the user. This machine was 
manufactured with the necessary amount of oil 
applied to ensure correct operation, making 
periodic oiling unnecessary.

If problems occur, such as difficulty turning the 
handwheel or an unusual noise, immediately stop 
using the machine, and contact your authorized 
dealer or the nearest authorized service center.

Do not store the machine in any of the locations 
described below, otherwise damage to the 
machine may result, for example, rust caused by 
condensation.

*

Exposed to extremely high temperatures

*

Exposed to extremely low temperatures

*

Exposed to extreme temperature changes

*

Exposed to high humidity or steam

*

Near a flame, heater or air conditioner

*

Outdoors or exposed to direct sunlight

*

Exposed to extremely dusty or oily environments

If the screen is dirty, gently wipe it with the 
included LCD cleaning cloth or a soft, dry cloth. 
Do not use organic solvents or detergents. 

If the surface of the machine is dirty, lightly soak a 
cloth in a neutral detergent, squeeze it out firmly, 
and then wipe the surface. Then wipe again with a 
dry cloth. 

If dust or bits of dirt collect in the race or bobbin 
case, the machine will not run well, and the 
bobbin thread detection function may not operate. 
Keep the machine clean for best results.

Press  

→ 

 → 

 → 

 → 

 in this order to display a 

video example of cleaning the race (see page 46). 
Follow the steps explained below to complete the 
operation.

• In order to extend the life of this machine, 

periodically turn it on and use it. Storing this 
machine for an extended period of time 
without using it may reduce its efficiency.

• Do not wipe the LCD screen with a damp 

cloth.

• Occasionally, condensation may form on the 

LCD screen or it may become fogged up; 
however, this is not a malfunction. After a 
while, the cloudiness will disappear.