Справочник Пользователя для Brother S-7000DD

 

 

S-7000DD 

29 

The standard height of the presser foot (1) is 6 mm when the 
presser foot (1) is raised by means of the lifting lever (2). 

1.  Loosen the nut (3) of the adjustment screw (4), and then 

turn the adjustment screw (4) so that there is no pressure 
applied to the presser foot. 

2. Raise the lifting lever (2). The presser foot (1) will also 

rise. 

3.  Remove the oil cap (5). 
4.  Loosen the bolt (6) and then move the presser bar (7) up 

or down until the presser foot (1) is at the standard height 
of 6 mm. 

5.  Tighten the bolt (6). 
6.  Replace the oil cap (5). 
7. Adjust the presser foot pressure using the adjustment 

screw (4), and then tighten the nut (3). 

 
 
 
 
 
 
 
 
 
 
 
 
NOTE: 

After adjusting, check that the needle moves down into 
the center of the groove in the presser foot. 

 
 
 
 
 
 

 

 
 
 
 
 
 

0534D

Needle