Справочник Пользователя для Brother S-7000DD

 

 

S-7000DD 

30

The standard height of the feed dog (1) when it is raised as 
far as possible above the surface of the needle plate is 0.8 
mm for -[]03 specifications, 1.0 mm for -[]03A specifications 
and 1.2 mm for -[]05 specifications. 

 

 

 

Becomes higher

Becomes lower 

0543D

<-[]03> 

0.8mm 

<-[]03A> 

1.0mm 

<-[]05> 

1.2mm

 

 

 

3862M

1.  Turn the pulley until the feed dog (1) rises to the highest 

position. 

2.  Tilt back the machine head. 
3.  Loosen the screw (2). 
4. Turn the feed lifting shaft crank (3) to move the feed 

bracket (4) up and down. 

5.  Tighten the screw (2). 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

The standard angle for the feed dog (1) when it is at its 
highest position above the needle plate is when the “ ” mark 
on the shaft (2) is aligned with the feed rocker bracket arm 
(3) and the feed dog (1) is parallel to the needle plate. 

0544D

3865M

Standard 

Raise 
the front 

Lower 
the front 

1. Turn the machine pulley to move the feed dog (1) to its 

highest position above the needle plate. 

2.  Tilt back the machine head. 
3.  Loosen the two set screws (4). 
4. Turn the shaft (2) in the direction of the arrow within a 

range of 90° with respect to the standard position.   

・ 

In order to prevent puckering, lower the front of the feed 
dog (1). (Fig. [A]) 

・ 

In order to prevent the material from slipping, raise the 
front of the feed dog (1). (Fig. [B]) 

5.  Securely tighten the set screws (4). 

NOTE: 

 

The height of the feed dog (1) will change after the angle 
has been adjusted, so it will be necessary to re-adjust 
the height of the feed dog (1).