Справочник Пользователя для WHP Wireless DL360

Action: 

1.  Disconnect power to the server. 

2.  Following the guidelines and cautionary information in the server 

documentation, strip the server to its most basic configuration by removing 
every card or device that is not necessary to start the server. Keep the 
monitor connected to view the server startup process. 

3.  Reconnect power, and then power the system on. 

− 

If the video does not work, refer to "Video Problems (on page 

  CAUTION:  Only authorized technicians trained by HP should 

attempt to remove the system board. If you believe the system board 
requires replacement, contact HP Technical Support before proceeding. 

− 

If the system fails in this minimum configuration, one of the primary 
components has failed. If you have already verified that the processor, 
PPM, power supply, and memory are working before getting to this 
point, replace the system board. If not, be sure each of those components 
is working. 

− 

If the system boots and video is working, add each component back to 
the server one at a time, restarting the server after each component is 
added to determine if that component is the cause of the problem. When 
adding each component back to the server, be sure to disconnect power 
to the server and follow the guidelines and cautionary information in the 
server documentation.  

 

Action: 

1.  Refer to the server and operating system documentation to be sure the server 

and operating system support the device. 

2.  Be sure the latest device drivers ("Maintaining Current Drivers" on page 

are installed.