Справочник Пользователя для Chaparral FS2620R

Connect the Fibre Channel cables to the router and the host computer/hub/ switch. 

You can use one or both FC connections. If only one connection is used, disable the 
unused FC connection. For information about disabling a channel, see 

Power up connected servers, hubs, or switches on the network if necessary.

You are now ready to configure the router. To view the default settings, see 

. For information about changing the default settings, see 

LED status lights are on the rear panel of the router. For information about 
troubleshooting problems indicated by the status lights, see 

.

Figure 2-4. LED status lights

Table 2-2 describes the meaning of the LED status lights located on the rear of the router.

Table 2-2. LED status lights

FT

Router fault

Red

Solid on when router is powered-up and 
fails any internal diagnostic or detects a 
critical error

ST

Router status

Yellow

Solid on when router is powered-up and 
passes all internal diagnostics

Yellow

Solid off when router either:

!

Detects a warning/degraded mode

!

Fails to boot