Справочник Пользователя для Znyx Networks bh5700
other words there is a unique vrid to ifname associated with the
–i option.
-s
Toggle preemption mode (Enabled by default). Preemption
means that a Master switch will go to Backup if a current Backup
has higher priority.
-M
Become MASTER when priority is equal. Be sure it is only
set on one host or the switches will oscillate. Must set –B
option on other hosts (requires preemption mode ! -s)
-B
Become BACKUP when priority is equal. See -M option
-S <script>
script to be called when state change occurs.
-a <auth> (not yet implemented) set the authentication type
auth=(none|pass/hexkey|ah/hexkey) hexkey=0x[0-9a-fA-F]+
auth=(none|pass/hexkey|ah/hexkey) hexkey=0x[0-9a-fA-F]+
-p <prio> Set the priority of this host in the virtual server
(default is 100)
-f <piddir>
specify the directory where the pid file is
stored (default is /var/run)
-c <conf> Configuration read from conf file (required when
managing multiple Virtual Routers). The contents of the conf
file are lines of command line options. Each line represents a
file are lines of command line options. Each line represents a
Virtual Router. Parameters given on the command line apply to
all Virtual Routers defined by the conf file. So for example, if
all Virtual Routers defined by the conf file. So for example, if
the command line reads:
vrrpd –d 50 –c vrrpd.conf
And the vrrpd.conf file contains:
-v 1 –i zhp0 –I zhp3 10.0.0.42
-v 2 –i zhp1 –I zhp3 11.0.0.42
vrrpd would be started controlling two Virtual Routers; one for
10.0.0.42 and the other for 11.0.0.42. They would both get a –d
10.0.0.42 and the other for 11.0.0.42. They would both get a –d
50 option.
-d <delay> Set the advertisement interval. Default is 1 second.
By default time is specified in seconds. If the delay value ends
By default time is specified in seconds. If the delay value ends
in a lower case ‘m’ the time is specified in milliseconds. The
millisecond specification results in a proprietary use of the
millisecond specification results in a proprietary use of the
VRRP Adver Int field.
-m <address>
Change the virtual MAC address from
00:00:5E:00:01:<vid> to the provided addr. The addr should be
input as 6 two digit hex numbers that are colon delimited with no
Ethernet Switch Blade User's Guide
release 3.2.2j
page 270