Справочник Пользователя для Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006

P/N: 4NZ020-010

12JAN07 v4.0 Nissan 350Z(4NZv4.0)

Fig. 11-a

11.

2005 “REV-UP” AND 2006 VEHICLE TIMING CONTROLLER INSTALLATION (For
2003-2005 Standard Engine Vehicles, Skip This Section and Proceed with Section 12)

Install the supplied “piggyback ECU” per the
instructions supplied with the unit.

Install the supplied fuel pump relay in the
passenger’s side/rear of the engine compart-
ment as shown. (See Fig. 11-a.)

Run the white-with-red-stripe wire and the
brown wire from the “piggyback ECU” con-
nector to the relay.

Attach the white-with-red-stripe wire to termi-
nal #85 on the relay using the supplied slide
connector. (See Fig. 11-b.)

Attach the brown wire and the supplied black
wire to terminal #30 on
the relay.

Attach one end of the
supplied fuse holder pig-
tail and the supplied red
(fuel pump power) wire to
terminal #86 using a
female slide connector.

Attach one end of the
supplied black (fuel pump
ground) wire to terminal
#87.

Attach the open end of
the fuse holder to the
positive battery terminal
using the supplied ring terminal connector.

Attach the fuel pump power wires to their
respective terminals using the supplied ring
terminal connectors.

Install the fuel pump fuse in the fuse holder
and install the supplied plastic wire loom over
the wires.

NOTE:

There is no “accessory cable functionality”

used with the supercharger kit and it should

be removed from the ECU if equipped.

#86 FEMALE SLIDE: FUSE HOLDER (WITH PIGTAILS)
AND 7' RED 14GA w/BARE END

#87 - BLACK 14GA WIRE w/BARE END

#85 - 4' WHITE/RED FROM UNICHIP CONNECTOR

#30 - 4' BROWN WIRE FROMUNICHIP PLUG AND 1'
WIRE 14GA WIRE/3/8" RING TERMINAL CONNECTOR

Fig. 11-b