Справочник Пользователя для Smarthome NSTEON KEYPADLINK 2486D
INSTEON KeypadLinc V2 Dimmer User’s Guide
3. Send an X10 ON or OFF command.
4. Send the following X10 Address sequence:
5. Send the X10 Scene Address (house code and unit code) that is to be removed.
6. KeypadLinc Dimmer will flash the light it is wired to, indicating that the X10 Scene Address has been
removed.
Remotely Setting the Ramp Rate for an X10 Scene Address
The Ramp Rate of each module in each X10 Scene is adjustable. If this setting is not adjusted,
KeypadLinc Dimmer will use the Ramp Rate for its X10 Primary Address.
KeypadLinc Dimmer will use the Ramp Rate for its X10 Primary Address.
1. Using an X10 Controller, send the CLEAR Sequence:
2. Send KeypadLinc Dimmer's X10 Primary Address (house code and unit code).
3. Use any controller to adjust KeypadLinc Dimmer’s brightness so it corresponds to the Ramp Rate you
want in the table below. If you use KeypadLinc Dimmer’s on/off buttons and you are careful, you can
set one of 32 brightnesses. Brighter is faster.
set one of 32 brightnesses. Brighter is faster.
4. Send the following X10 Address sequence:
O16
P16
M16
N16
O16
N16
M16
P16
M16
Bright-
ness
Level
Ramp
Rate in
Seconds
Bright-
ness
Level
Ramp
Rate in
Seconds
Bright-
ness
Level
Ramp
Rate in
Minutes
100%
0.1
65%
26
29%
2.5
97%
0.2
61%
28
26%
3.0
94%
0.3
58%
30
23%
3.5
90%
0.5
55%
32
19%
4.0
87%
2.0
52%
34
16%
4.5
84%
4.5
48%
38
13%
5
81%
6.5
45%
43
10%
6
77%
8.5
42%
47
6%
7
74%
19.0
39%
60
3%
8
71%
21.5
35%
90
0%
9
68%
23.5
32%
120
N16
O16
P16
M16
5. Send the X10 Scene Address (house code and unit code).
6. KeypadLinc Dimmer will flash the light it is wired to, indicating that the new Ramp Rate has been set
for the X10 Scene Address.
Page 29 of 38