Справочник Пользователя для Smarthome NSTEON KEYPADLINK 2486D

 

The On Button makes your light go ON and the Off Button makes your light go OFF. 

•  Tap the On Button to make your light go at the Local Ramp Rate from whatever brightness it currently 

has to the Local On-Level brightness. 

•  Tap the Off Button to make your light go at the Local Ramp Rate from whatever brightness it currently 

has to full-OFF. 

•  Double-tap the On Button to make your light go full-ON quickly. 
•  Double-tap the Off Button to make your light go full-OFF quickly. 
•  Press and hold the On Button to gradually brighten your light from whatever brightness it currently 

has to full-ON. 

•  Press and hold the Off Button to gradually dim your light from whatever brightness it currently has to 

full-OFF. 

 

Ramp to On-Level 

Fast ON 

Brighten 

Ramp to OFF 

Fast OFF 

Dim 

 

Pulling the SET Button at the bottom of the switch out as far as it will go (about 1/8”) opens mechanical 
contacts that remove all power from KeypadLinc Dimmer and the load that it controls.  “Air gapping” can 
be useful for replacing bulbs or any other time you want the controlled circuit to be unpowered. 

Because KeypadLinc Dimmer’s settings are stored in non-volatile memory, setup information will not be 
lost when the unit unpowered. 

 

 
If you press the SET Button in too far when you undo the air gap, you might inadvertently reset
KeypadLinc V2 Dimmer to its factory default settings.  Just push the button in until its top is even with
the Trim Frame. 

Page 30 of 38