Справочник Пользователя для Sapphire Audio DV425TR

02/01                                                                                     Page 33                                                                               250-5533

NOTE:  Maximum number of 90° elbows permitted for a vertical installation is four, provided the termination 

falls within the shaded area shown in vent graph on page 33.  See also Figure 12 below, within the 4, 90’s 

configuration, the maximum allowable pipe length on the horizontal runs is 1’, the minimum allowable pipe 

length on vertical runs is 1’.  ADDITIONAL RESTRICTION:  This installation may not have two horizontal 

sections connected by 90° elbows. 

 

Set the gas stove in its desired location. Drop a plumb bob down from the ceiling to the position of the 

stove flue exit, and mark the location where the vent will penetrate the ceiling. Drill a small hole at this 

point. Next, drop a plumb bob from the roof to the hole previously drilled in the ceiling, and mark the spot 

where the vent will penetrate the roof. Determine if ceiling joists, roof rafters, or other framing will obstruct 

the venting system. You may wish to relocate the stove, or to offset, as shown in Figure 11, to avoid cutting 

loadbearing members.

 

To install the round support box/wall thimble in a flat ceiling, cut a 10" (254mm) square hole in the 

ceiling, centered on the hole drilled in Step2.  Frame the hole as shown in Figure 13.

2'

1'

2'

1'

1'