Справочник Пользователя для Sapphire Audio DV425TR

02/01                                                                                     Page 52                                                                               250-5533

1. 

Check the pilot flame.  It should engulf approximately 3/8” of the top of the millivolt generator and engulf 

the top of the thermocouple (see illustration  on page 52).

2. 

Shut off gas to the stove by turning the valve control knob to “OFF” and turning off the manual shutoff 

valve.  Allow the stove to cool for 15 minutes.  Remove the door.

3. 

Remove the logset (NOTE: the logs are fragile.  If any log is cracked or deteriorated, replace it when 

reinstalling.  Check the logs for sooting.  A small amount of soot along the bottom of the logs is normal.  

If excessive sooting is found, the fireplace will require adjustment.  Contact your dealer.

4. 

Clean the burner pan (especially in the burner holes and slots) and inspect the following:

a. 

Check for burner pan holes that are cracked, severely warped, plugged or corroded.

b. 

Make sure the burner pan assembly fits flat against the floor of the firebox.  

c. 

Check the firebox and area around the pilot to make sure there is no warping or damage.  If any 

problem is found, discontinue use and contact your dealer for service.

5. 

Reinstall the logset.  Inspect the door glass, if the door glass is damaged, contact your dealer for a 

replacement.  Make sure the gasket along the perimeter of the glass contacts the face of the firebox and 

forms an airtight seal.  If it does not, realign or replace the gasket to ensure an airtight seal. Reinstall 

door. 

6. 

Inspect the area behind the side panels.  Check the gas control valve and all of the gas lines.  If any 

damage is found, discontinue use and contact your dealer for service.

7. 

Remove any debris or vegetation near the vent termination, outside the house ensuring that the flow 

of combustion and ventilation air is not obstructed.  Contact your dealer if any sooting or deterioration 

is found near the vent termination.

8. 

Turn on gas and follow Lighting Instructions. The flames should be orange/yellow and not touch the 

top of the firebox.  If the pilot or main burners do not burn correctly, contact your dealer for service.  

Monitor the blower operation.