Справочник Пользователя для Roberts Radio SOUND66

1.  Fully extend the telescopic aerial. The aerial should be fully extended 

and positioned vertically for optimum reception.

2. Press 

the 

On / Standby button to switch on your sound system.

3. Press 

the 

FM button to select the FM band.

4.  Press and hold down the Tuning Up button for 2 - 3 seconds to cause 

your radio to search from low frequency to high frequency and to stop 
automatically when it fi nds a station of suffi cient strength.

5.  After a few seconds the display will update. The display will show the 

frequency of the signal found. If the signal is strong enough and there 
is RDS data present then the radio will display the station name.

6. To fi nd other stations press and hold the Tuning Up button as 

before.

7.  Press and hold down the Tuning Down button for 2 - 3 seconds to 

cause your radio to search from high frequency to low frequency and 
to stop automatically when it fi nds a station of suffi cient strength.

8.  When the end of the waveband is reached your radio will recommence 

tuning from the opposite end of the waveband.

9. Adjust 

the 

Volume to the required setting.

10. To switch off your sound system press the On / Standby button.

3

Note: 
If you fi nd that FM reception is poor, try repositioning the Telescopic aerial 
fully extend and position vertically for optimum reception. If you fi nd that 
an FM broadcast has a lot of background hiss, this may often be reduced 
by setting the radio into Mono reception mode for the current FM station. 
Please refer to the section "Stereo / Mono setting - FM" on page 36 for 
further details.

2

4,6

7