Справочник Пользователя для Paxton Automotive Musical Table 4PFX020-020
5-3
P/N: 4PFX020-020
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
24APR06 v1.1 MusGT(4PFX..020 v1.1)
Fig. 5-g
5.2
THROTTLE CABLE INSTALLATION
A.
Using a small square file, file two grooves
in the firewall where the throttle cable goes
through. Reference the cable housing for
dimensions.
in the firewall where the throttle cable goes
through. Reference the cable housing for
dimensions.
*** NOTE ***
The grooves should be in the 12 and 6 o:clock posi-
tions.
tions.
B.
Install the cable in the firewall and connect
to the stock accelerator pedal.
to the stock accelerator pedal.
C.
Mount the throttle cable bracket to the car-
buretor enclosure using the supplied hard-
ware. (See Fig. 5-g.)
buretor enclosure using the supplied hard-
ware. (See Fig. 5-g.)
D.
Secure the throttle cable to the mounting
bracket.
bracket.
E.
Install the throttle return-spring bracket to
the linkage arm using one 10-32 x 1/2" but-
ton-head screw. (See Fig. 5-f.)
the linkage arm using one 10-32 x 1/2" but-
ton-head screw. (See Fig. 5-f.)
F.
Connect the cable to the linkage arm using
the Vortech retainer and washer. The retainer
should go through the cable end, washer,
return-spring bracket and into the arm.
the Vortech retainer and washer. The retainer
should go through the cable end, washer,
return-spring bracket and into the arm.
*** NOTE ***
There is a plastic sheath that nomally protects the
cable. Remove this as it may hang-up on the end of
the cable housing.
cable. Remove this as it may hang-up on the end of
the cable housing.
G.
Install the throttle return spring.
WASHER
THROTTLE
CABLE
CABLE
10-32
BUTTON HEAD
VORTECH RETAINER
H.
Check for full throttle by pressing the accel-
erator to the floor and verifying that the car-
buretor butterflies open fully.
erator to the floor and verifying that the car-
buretor butterflies open fully.
I.
If possible, pressurize the fuel system and
check for leaks.
check for leaks.
J.
Using the supplied 5/16" cap screws, install
the top cover on the enclosure and tighten
the screws.
the top cover on the enclosure and tighten
the screws.
K
.
Use the supplied hardware to plug any open
holes in the carburetor enclosure and cover.
holes in the carburetor enclosure and cover.