Руководство По Работе для Panasonic Attune II
20
■ Wiring
These servicing instructions are for use by qualified personnel only. To reduce the risk of electric
shock do not perform any servicing other than that contained in the operating instructions unless
you are qualified to do so. Refer all servicing to qualified service personnel.
shock do not perform any servicing other than that contained in the operating instructions unless
you are qualified to do so. Refer all servicing to qualified service personnel.
Wiring to the Speaker Microphone
When connecting a cable to the unit for the microphone, use a shielded cable. Non-shielded
•
cables can also be connected to the unit for the speaker.
Connect the
Connect the
•
cable from the center module to the provided plug connector. At the factory, the
plug connector has already been inserted into the socket connector on the end of the cable
connected to the unit. Before the wiring, detach the plug connector from the socket connector.
From the left, the wiring order for the plug
connected to the unit. Before the wiring, detach the plug connector from the socket connector.
From the left, the wiring order for the plug
•
connector is “GND (shield)”, “–” and “+”. When using
the unit for the speaker, the unit can operate normally with or without the GND (shield) terminal
wiring.
wiring.
Use the “minus” screwdriver and loosen the M2.5 screw located on the upper surface of the
1.
plug connector. Peel off the sheath from the tip of the wiring material and insert the cable tip in
the plug connector.
the plug connector.
Length to be stripped: 7 mm ±1 mm {9/32 inches ±1/16 inches}
Firmly tighten the loosened screw by means of the “minus” screwdriver. Repeat the above-
Firmly tighten the loosened screw by means of the “minus” screwdriver. Repeat the above-
2.
mentioned same procedure for each terminal.
(Tightening torque: 0.49 N·m to 0.59 N·m {0.36 lbs·ft to 0.44 lbs·ft})
Mount the cabled plug
Mount the cabled plug
3.
connector to the socket connector at the end of cable from Speaker
Microphone.
Note:
Insert the
•
plug connector firmly into the socket connector.
Wires
The applicable cross section of wire for the provided plug
•
connector is 1.3 mm
2
to 0.1 mm
2
(AWG16- AWG28).
When using the unit for the microphone, connect a shielded cable which meets the condition
When using the unit for the microphone, connect a shielded cable which meets the condition
•
described above.
Socket connector
Plug connector
“GND (shield)”
“–”
“+”
GND : Gray
– :
– :
Black
+ :
Red
7 mm ±1 mm
{9/32 inches
±1/16 inches}
{9/32 inches
±1/16 inches}