Справочник Пользователя для North Star M268180M
Assembly (continued)
13
8. Connect all three
powe r cords
togethe r
togethe r
Connect the three sprayer powe r cords toge the r.
a) Check to be sure the power switch is in the “ OFF” position on the remote
switch power cord.
b) Connect the one end of the remote switch power cord to the battery power
cord and the other end to the pump power cord.
9. Attach remote switch
to vehicle
Using supplie d velcro pads, affix remote switch to vehicle in a position that is
easily reache d from the drive r’s seat.
easily reache d from the drive r’s seat.
10. Disconne ct afte r use
AFTER EAC H USE, disconnect powe r to the spraye r by disconnecting the
sprayer’s remote switch power cord from the battery power cord – the battery
power cord m ay rem ain connected to the battery.
sprayer’s remote switch power cord from the battery power cord – the battery
power cord m ay rem ain connected to the battery.
NOTE: It is important to disconnect power to the sprayer when not in use,
both for safety reasons and to prevent the pump from draining the battery.
ALWAYS verify that the power has been disconnected before servicing the
sprayer.
both for safety reasons and to prevent the pump from draining the battery.
ALWAYS verify that the power has been disconnected before servicing the
sprayer.
11. To disconne ct
pe rmanently
When it is necessary to disconne ct the spraye r’s battery powe r cord from the
batte ry, use the following proce dure:
batte ry, use the following proce dure:
1. Disconnect sprayer’s remote switch power cord from the battery power cord.
2. Disconnect the battery power cord from the vehicle battery as follows:
2. Disconnect the battery power cord from the vehicle battery as follows:
a) Disconnect vehicle battery ground wire.
b) Disconnect the battery cord’s black battery clamp or black wire
b) Disconnect the battery cord’s black battery clamp or black wire
connector from the negative(-) terminal of the vehicle battery.
c) Disconnect the battery cord’s red battery clamp or red wire
connector from the positive(+) terminal of the vehicle battery.
d) Reconnect the vehicle battery ground wire.
W ARNING: Always connect in this sequence to avoid possible shock.
(Rem em ber that on som e vehicle m odels, you may need to remove the sprayer to
access the battery)
access the battery)
01981
Battery power cord
Remote switch
power cord
Pump power cord
To Battery