Справочник Пользователя для MPC OM-20000072
62
MPC User Manual Rev 0D
Chapter 6
Software Programs
CONFIGURE ETHERNET PORT
An example of the Configure Ethernet Port window is shown in Figure 58.
Figure 58: Configure Ethernet Port
Select whether to enter the IP address for the modem connection in the Set IP field, or select Obtain an
IP Automatically for the IP address to be assigned automatically.
IP Automatically for the IP address to be assigned automatically.
If you selected the Set IP field, enter the address of the system of interconnections within the
communications system that allows the components to communicate directly with each other in the
Enter Sub Net Mask field. Enter the default gateway address in the Enter Default Gateway field.
communications system that allows the components to communicate directly with each other in the
Enter Sub Net Mask field. Enter the default gateway address in the Enter Default Gateway field.
Click on the OK button to save your changes, or click on the Cancel button to cancel the settings and
return you to the main Network Setup page.
return you to the main Network Setup page.
* Some of these parameters can also be adjusted via the VFD panel on the MPC.
6.1.2.5
Receiver Setup
Click on the Receiver Setup button in the main Configuration Setup window to bring you to the
Receiver Setup window as seen in Figure 59. There are three options in this screen that are described
further in this section:
Receiver Setup window as seen in Figure 59. There are three options in this screen that are described
further in this section:
• Set Up Base Station
• List Current Configuration
• Parsing Responses
Figure 59: Receiver Setup