Справочник Пользователя для Iveco S30 ENT M23
installation directiVe
1
MAY 2006
S30 ENT M23
7. COMPONENTS SUPPLIED WITH THE ENGINE
Figure
06_019_S
*&#
0&
!
-
:
6
7
5
4
1. Connectors to be assembled - 2. Conductor terminals - 3. Gaskets to be fitted on individual wires - 4. PF connector rear cover -
5. Fuel electric pump - 6. Fuel pre-filter - 7. Fuel filter - 8. Components to replace fittings mounted on the fuel filter.
The engine is supplied with a box containing the parts
showed in the pictures, as well as spring supports to allow
keelson anchoring.
Electric connectors
As shown in pictures 1, 2, 3, 4, they must be used to set up
the cabling connecting them to the components located on
the fuel filter.
Individual electric connectors are each one sealed in see-
through bags, together with small parts required to com-
plete them. In order to avoid connection errors, connectors
are different from one another; each one of them must be
exclusively mounted by using the small parts contained in the
relevant plastic bag
connection function
o
A. Fuel temperature sensor for EDC
o
M. Sensor designed to detect the presence of water in
the fuel pre-filter
o
Z. Fuel filter clog sensor
o
PF. Heating element on the fuel filter
o
JFC. Connection to the JFC connector on the engine
harness
Chapter 9 shows the instructions to be followed to perform
connections.
Mechanical components
As shown in picture 8, they must be used to replace the fit-
tings mounted on the fuel filter support.
Chapter 8 shows the instructions to be followed in order to
carry out assembly operations.
Hydraulic components
Identified in the picture by numbers 5, 6, 7, hydraulic compo-
nents must be used to set up the fuel feeding system.
Chapter 8 shows the instructions to be followed in order to
perform connections.