Справочник Пользователя для InterAct Accessories 4040A

        

 

                                                                                                                                         

           

 

                                                                         

 

 

14

 
 
 
 
 
 

3. Varying the duty cycle setting results in a slight change in 

frequency. Adjust the COARSE and FINE frequency controls 
as required. 

In gated burst mode of operation, the generator output is switched 

on and off (gated), either by an internally generated signal or by an 
externally applied signal. Both the repetition rate and the duty cycle 
are variable. Fig. 5 illustrates the type of waveform generated and 
summarizes the control settings used to obtain the desired waveform. 
 
Internal Triggering 
 

1. Select the waveform to be gated by pushing in the appropriate 

FUNCTION switch. Display the output of the generator on an 
oscilloscope. 

2. Adjust the frequency, amplitude, symmetry, and dc offset of the 

signal by using the main generator controls. 

3. Enable the burst mode by pushing in the BURST ON switch. 
4. Set the repetition rate of the burst with the SWEEP TIME 

control. 

5. Adjust the tone burst duty cycle, or adjust the tone burst width 

to a specific time period, with the BURST WIDTH control. 

 

 

1. Select the waveform to be gated by pushing in the appropriate 

FUNCTION switch on the front panel. 

2. Adjust the frequency, amplitude, symmetry, and dc offset of the 

signal by using the main generator controls.