Техническая Спецификация для I-Data Electronic Documentation ida
Connecting to System
ida FS 250, Operator's Guide
ida FS 250, Operator's Guide
-12-
3. Installation and Connections of the
ida FS 250
ida FS 250
This chapter starts with an overview of the functionality of the rear panel.
Then follows a description of how you connect the ida FS 250 box to a
printer and finally you will find instructions for connection to a system.
Then follows a description of how you connect the ida FS 250 box to a
printer and finally you will find instructions for connection to a system.
NOTE:
Before you start the installation, make sure that you set the address
switch and the desired emulation. See the description in the section
Before you start the installation, make sure that you set the address
switch and the desired emulation. See the description in the section
:
Emulation.
3.1 The Rear Panel
RS232
12-18 VDC.
0.7A
PARALLEL IN
PARALLEL OUT
ADDR
+
--
B
A T 6
5
4
3
2
0
1
A = PCL
Fig 2-1 ida FS 250 Rear Panel
PARALLEL OUT
The parallel output port is connected to the parallel/Centronics in put port
on the target printer (standard parallel out cable supplied with printer
should be used).
The parallel output port is connected to the parallel/Centronics in put port
on the target printer (standard parallel out cable supplied with printer
should be used).
PARALLEL IN
The parallel input port can be connected to the parallel/Centronics out put
on a PC or similar source which enables it to share the printer with the
host. For this connection you need a spare part cable ending in a 25-pole
D-Sub connector (i-data order no. 999022 030).
The parallel input port can be connected to the parallel/Centronics out put
on a PC or similar source which enables it to share the printer with the
host. For this connection you need a spare part cable ending in a 25-pole
D-Sub connector (i-data order no. 999022 030).
SERIAL (IN/OUT) RS232
The serial port can be configured either as input or as output.
Default configuration is input.
The serial port can be configured either as input or as output.
Default configuration is input.
Serial input
The serial port is connected to the serial output on a PC or similar source able
to share the printer with the host.
The serial port is connected to the serial output on a PC or similar source able
to share the printer with the host.