Техническая Спецификация для I-Data Electronic Documentation ida
Connecting to System
ida FS 250, Operator's Guide
ida FS 250, Operator's Guide
-14-
3.2 Emulation
As a default the ida FS 250 will emulate IBM 3812/5219/3816.
The ida FS 250 PDS emulates IPDS as a default.
You can select emulation in two ways. Either via the address switch or via the
line using FSL function Y37.
line using FSL function Y37.
The following emulations are supported by the ida FS 250:
IBM 3812/5219/3816
IBM 5224
IBM 5225
IBM 5256
IBM 4234
IBM 5224
IBM 5225
IBM 5256
IBM 4234
If you wish to see the current emulation, you can generate a test printout by
turning the address switch to the T-position.
turning the address switch to the T-position.
3.2.1 Via the Address Switch
Emulation selected on the address switch is described below.
The T-cable must be disconnected from the converter before changing
emulation.
emulation.
NOTE: Make sure that you have set the address switch before you switch
power on.
Select emulation on the address switch as follows:
1. Switch off the box.
2. Turn the address switch to the "T" position. Switch on power to box.
3. When the ida FS 250 is ready, it will eject a page with the following
message:
"Current emulation is xxxx"
4. When the address switch is turned to a new position, a new message
stating the current emulation will be printed after a few seconds.
5. When the desired emulation has been set, you must switch power off and
set the address correctly again (values 0-6). Select one of the following
emulations shown below.
emulations shown below.