Справочник Пользователя для Hughes HN7700S
Chapter 8 • Configuring the HN router for VADB backup
1037753-0001 Revision A
65
If the
current_state
field changes to SESSION INACTIVE and
there is no connection to the satellite (you can’t browse),
troubleshoot by verifying that the HN router can ping the VADB
gateway:
troubleshoot by verifying that the HN router can ping the VADB
gateway:
1. Open the Run dialog box by selecting
Start
→
Run
.
2. Type
Command
.
3. Click OK.
4. Type
4. Type
ping <VADB gateway address>
and press E
NTER
.
The VADB gateway address appears on the VADB Config
Show page (Figure 52 on page 59).
If the client fails to ping the host, the computer reports no
packets received. This indicates a problem with either the
network hardware or configuration. Check the LAN
connections and refer to the instructions that were provided
with the network hardware, then retry the ping test.
Show page (Figure 52 on page 59).
If the client fails to ping the host, the computer reports no
packets received. This indicates a problem with either the
network hardware or configuration. Check the LAN
connections and refer to the instructions that were provided
with the network hardware, then retry the ping test.
LED appearance during
VADB operation
VADB operation
The System LED steadily flashes when VADB is enabled. The
System LED is on when the satellite link is enabled. The HN
router LEDs are shown in Figure 58. Table 3 describes the
appearance of the LEDs during VADB operation.
System LED is on when the satellite link is enabled. The HN
router LEDs are shown in Figure 58. Table 3 describes the
appearance of the LEDs during VADB operation.
Figure 58: HN router LEDs