Справочник Пользователя для Electrolux FN620K

Be sure tines do not rotate when engine is running and tine 
control is in the “OFF” position.

FINAL CHECK “OFF” POSITION
•      With tine control “OFF” (up), push down on handle to 

raise tines off the ground.

•      Slowly pull recoil starter handle while observing tines.  

Tines should not  rotate.

•      If tines rotate, place loop of idler spring in a lower link 

of chain and retest.

FINAL CHECK “ON” POSITION
•         With tine control “ON” (held down to handle) push down 

on handle to raise tines off the ground.

•      Slowly pull recoil starter handle while observing tines.  

Tines should rotate forward.

•     If tines do not rotate, place loop of idler spring in a 

higher link of chain and retest.

NOTE:  If “ON” position check required adjustment, re check 
“OFF” position adjustment to insure tines do not rotate when 
control is “OFF” (up).

NOTE:  Additional tine arrangements can be attained by 
moving outer tines to opposite side of tiller which will point 
tines outward.  Always keep sharp edges of tines rotating 
forward from above.

•      Remove screws from side of belt guard.
•      Pull belt guard out and away from unit.
•      Replace belt guard by reversing above procedure.  Be 

sure slot in bottom of belt guard is under head of tine 
shield bolt and all nuts are tightened securely.