Справочник Пользователя для Chip PC CDC01927

 
 
 
 
 
 

 

12 

Jack PC Hardware User Manual - Training Department 
Version 0506 
 

 

Tools you will need for Existing Jack Installation: 

•

 

Power-over-Ethernet Tester (where PoE is available (see power options 1 and 2 in 
the introduction chapter) – it is recommended to verify that the LAN jack receives 
power with this tester) - this is an optional accessory that you need to purchase 
separately (Chip PC part number: CPN02239 – see accessories list). 

•

 

Screwdriver / Powered-screwdriver 

•

 

RJ-45 Termination Connector Block (this is an optional accessory that you need 
to purchase separately) 

•

 

Half-round File to trim wall cutout  

•

 

Cloth to clean Housing contacts 

•

 

Extraction Tool to remove device after it was installed 

 

1 

Use Power-over-Ethernet tester 
(Chip PC part number: CPN02239) 
to check existence of PoE in the 
Jack designated for installation.  
 
Note: In case there is no PoE 
available, Jack PC can be powered 
by External power supply (see step 
13). 
 

2 

Remove the existing LAN Jack from 
the wall.  
 
Separate the LAN Jack module from 
the front panel. 

3 

Pull out the LAN cable, holding the 
RJ-45 Termination Connector Block,  
 

4 

Connect the LAN jack and RJ-45 
connector on the RJ-45 Termination 
Connector Block (this is an optional 
accessory that you need to purchase 
separately, in case you did not order 
this part – go to New installation 
paragraph (3.5), and continue the 
instructions in the table from step 3).