Инструкции Пользователя для Canon Microfilm Scanner 300

39

■ USER MODE ■

• Default of the power saver mode at factory shipping

is set to 

 so that the unit switches into the power

saver mode if not operated more than 15 minutes.

• The power saver mode can be canceled by any key

operation.

• When the FS Controller I and III is attached, the unit

cannot switch into the power saver mode.

This feature is available in the DMP mode and enables you to
speed up scanning by simplifying the startup operation.

 : Normal mode (set at the factory before shipping)

 : Hi-speed scanning mode

In the hi-speed scanning mode, the scanner delivers
printouts of the images upside down.

When using the DMP mode, you can select one of the following
scanning resolutions.

 : 600DPI

 : 300DPI (set at the factory before shipping)

This mode is enabled when the scanner is connected to the Fileprint
450 and used in the DMP mode so as to clean the fixing rollers of
the printer. (

➞ P.43 “Cleaning mode”)

 : Normal mode (set at the factory before shipping)

 : Cleaning mode (Cleaning paper: A4 sized)

 : Cleaning mode (Cleaning paper: Letter sized)

You need to prepare a sheet of paper of the size se-
lected for cleaning and print the cleaning pattern on
the paper before you start cleaning the fixing rollers.

This feature is enabled when the optional DMP board is installed
in the scanner so as to switch to either of the following modes.

 : Scanner mode

 : DMP mode (set at the factory before shipping)

The MS300 can be used as a scanner even if the op-
eration mode is set to the [DMP mode]; however, the
Reader-Printer mode will be disabled in this case. To
enable the Reader-Printer mode, be sure to switch to
the [Scanner mode].