Справочник Пользователя для Atari 040-0050-01

 

Section 2  –  Cabinet Conversion 

 

 

© 2004 GLOBAL VR

®

, INC. 

040-0050-01

 Rev. A 10/29/2004 

 

Page 23 of 48 

4.  Place the joystick direction sticker over the joystick hole.  Make sure that it is properly 

aligned with the cabinet and monitor and then peel off the backing and apply the sticker.  
If the sticker has protective paper over the face, wet the paper and wait about 15 minutes 
before removing it to avoid damaging the artwork. 

5.  Center the button function stickers about 3/4-inch below the button holes as shown in the 

picture that follows.  The Missiles buttons are outboard and the cannon buttons are 
inboard.  Once the graphics are lined up properly, peel off the backing and apply each 
sticker. 

 

6.  Once all of the control panel graphics have been applied, re-install the clear plastic 

control panel cover and secure it with the nuts and bolts removed previously.   

Install Buttons and Connect Wiring 

1. Install 

the 

buttons 

on the control panel. 

2.  If your cabinet has an extra button hole that is not used by the gvrSX™ system, install the 

button plug from the kit to cover the unused button hole. 

3.  Re-install the joystick handle. 

4. Connect 

the 

joystick 

harness to the joystick. 

5.  Refer to the labels on each wire of the button harness and connect the wires to the correct 

buttons.  Note that the trigger button wires connect to the joystick. 

6.  Use wire ties to secure the wires so that they won’t get pulled or pinched when the 

control panel and service tray are opened or closed, as shown in the figure below.