Справочник Пользователя для Atari 040-0050-01
Section 2 – Cabinet Conversion
gvrSX™ Conversion System Manual
Page 24 of 48
Page 24 of 48
040-0050-01
Rev. A 10/29/2004
Apply the Cabinet Graphics and Marquee Artwork
GLOBAL VR
®
requires that all converted cabinets adhere to the strict guidelines for finished
cabinet artwork as described in this instruction manual. Perform the following steps to apply
the side panel graphics and replace the old marquee artwork.
the side panel graphics and replace the old marquee artwork.
1. Place a gvrSX™ Logo sticker on each side of the cabinet, centered, level to the ground, at
about eye level, as shown in the picture below. After determining placement, peel off the
backing and apply the graphic stickers.
backing and apply the graphic stickers.
2. Remove the screws from the top bracket that holds the marquee glass and artwork to the
cabinet, as shown by the arrows in the picture below.
3. Clean both sides of the marquee glass.
4. Insert the new marquee graphic. Center it in the marquee and trim the excess graphic
material from the edges as necessary.
5. Re-install the glass and top bracket.