Справочник Пользователя для American Power Conversion 3-in-1 Wireless Mobile Router

Using the AP/Router Setup Screen

4-3

This feature can be used to prevent unknown Wireless stations from using this access point. To use this 

feature:
1. Enable this checkbox.

2. Click the Trusted Stations button to open a sub-window containing the Trusted Wireless 

Stations screen.

3. Enter details of the Trusted Wireless Stations. See the following section for further details.

Clicking this button copies the Wireless settings, including the Trusted Station list, from the AP 

screen to this screen.
This is only useful if the AP Setup screen is already configured.
The SSID will not be copied. Each mode must use a different SSID. Using the same SSID for different 

modes would confuse Wireless clients.

The current IP address for the Ethernet port. This will be blank if:

The APC 3-in-1 Wireless Mobile Router is not in AP/Router mode.

The APC 3-in-1 Wireless Mobile Router is in AP/Router mode, but there is no active connection on 
the Ethernet (WAN) port.

The MAC address, also called the Physical address, is a low-level identifier for Ethernet connections. 

This field displays the MAC address for the Ethernet (WAN) port.

The login method is the type of connection used on the Ethernet (WAN) port. 
The default value is Travel Mode (Hotel). This mode requires no additional information.
To change the Login Method, click the Configure button.

This field indicates the current status of the connection on the Ethernet (WAN) port.
This field can only display Connected if the APC 3-in-1 Wireless Mobile Router is in AP/Router mode.

The DMZ PC will receive all incoming traffic for which the correct destination PC is unknown. 
This field shows the current DMZ PC. 
The default value is None, meaning the DMZ feature is disabled.

The IP address of the APC 3-in-1 Wireless Mobile Router on the Wireless LAN.
The default value is 192.168.1.1
To change any settings while in AP/Router mode, connect to the APC 3-in-1 Wireless Mobile Router 

using this IP address.
Normally, it is not necessary to change this IP address. 
Users MUST change this address if the LAN/WAN on the Ethernet (WAN) port is using the same IP 

address range (192.168.1.1 ~ 192.168.1.254).
Note: In AP/Router mode, the APC 3-in-1 Wireless Mobile Router has 2 IP addresses, one for 

The subnet mask for the IP address above.
The default value is 255.255.255.0, which is the standard value for small networks.

The DHCP Server will provide an IP address and related information to Wireless clients when they 

connect to the APC 3-in-1 Wireless Mobile Router.
The default value is Enabled.