Инструкции Пользователя для Biostar P4TPT

English

ection 6. Installation and Setup

This section will guide you through the installation of the

CPU, DDR Module, and also jumpers, and all the information about
the components on the motherboard. Not only can you find the
installation steps, but also the details and locations of the
components on the motherboard.

1. CPU Installation

The motherboard supports the Intel Pentium

Socket-478 processor. When

you are installing the CPU, make sure the CPU has a cooling fan attached on the right
to prevent overheating. If you do not find the cooling fan, contact your dealer and make
sure to install them before turning on the computer.

Step1: Pull the lever sideways away from the socket and then raise the

lever up to a 90-degree angle.

Step2: Look for the white dot/cut edge. The white dot/cut edge should

point towards the lever pivot. The CPU will fit only in the cor-
rect orientation.

Step3: Hold the CPU down firmly, and then close the lever.
Step4: Put the CPU fan on the CPU and buckle it. Connect the CPU fan

power cable to the JCFAN1. This completes the installation.

Step1

Step2

Step3

Step4

2. Fan Headers

These fan headers support cooling fans built in the computer. The fan wiring and

plug may be different according to the fan manufacturer. Connect the fan cable to the

connector while matching the black wire to Pin 1.

(1) CPU Fan Headers: JCFAN1

Assignment

Ground

+12V

FAN RPM Rate Sense