Инструкции Пользователя для Biostar P4TPT

12

12

12

12

12

English

English

English

English

English

(2) System Fan Headers: JSFAN1 (Optioanl)

   Pin   Assignment
   1

  Ground

   2

  +12V

   3

  FAN RPM Rate Sense

3. Installing DDR Module

3. Installing DDR Module

3. Installing DDR Module

3. Installing DDR Module

3. Installing DDR Module

1. Unlock a DIMM slot by pressing

the retaining clips outward.
Align a DIMM to the slot in
the way that the notch of the
DIMM matches the break of
the slot.

2. Insert the DIMM firmly and

vertically into the slot until the
retaining chip snap back in place
and the Dimm is properly
seated.

4. How to set up Jumpers?

4. How to set up Jumpers?

4. How to set up Jumpers?

4. How to set up Jumpers?

4. How to set up Jumpers?

The illustration shows how to set up jumpers. When the Jumper cap is placed

on pins, the jumper is “close”. If no jumper cap is placed on the pins, the jumper is
”open”. The illustration shows a 3-pin jumper whose pin1and 2 are “close” when
jumper cap is placed on these 2 pins.

Jumper open                 Jumper close                 Pin1-2 close

5. Jumpers, Headers,  Connectors & Slots:

5. Jumpers, Headers,  Connectors & Slots:

5. Jumpers, Headers,  Connectors & Slots:

5. Jumpers, Headers,  Connectors & Slots:

5. Jumpers, Headers,  Connectors & Slots:

The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.

1