Инструкции Пользователя для Biostar NM70I-1037U
NM70I-847/NM70I-807/NM70I-1007U/NM70I-1037U
7
C. Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
DDR3_A1
DDR3_B1
Disabled O
X
Disabled X
O
Enabled O
O
(O means memory installed, X means memory not installed.)
Note: The DRAM bus width of the memory module must be the same (x8 or x16)
2.3 Expansion
Slots
PEX16_1: PCI-Express Gen2 x8 Slot
-
PCI-Express 2.0 compliant.
-
Data transfer bandwidth up to 4GB/s per direction; 8GB/s in total.
Install an Expansion Card
You can install your expansion card by following steps:
1.
1.
Read the related expansion card's instruction document before
install the expansion card into the computer.
install the expansion card into the computer.
2.
Remove your computer's chassis cover, screws and slot bracket
from the computer.
from the computer.
3.
Place a card in the expansion slot and press down on the card until it
is completely seated in the slot.
is completely seated in the slot.
4.
Secure the card’s metal bracket to the chassis back panel with a
screw.
screw.
5.
Replace your computer's chassis cover.
6.
Power on the computer, if necessary, change BIOS settings for the
expansion card.
expansion card.
7.
Install related driver for the expansion card.