Инструкция С Настройками для Burnham ES2 ES2

THE BOILER CONTAINS REFRACTORY  

CERAMIC FIBER, a possible human carcinogen 

Use a NIOSH approved respirator when servicing 

high-temperature insulation and gasket materials.  

Wash exposed skin gently with soap and water 

after contact  Wash exposed clothing separate 

from normal laundry.

LABEL ALL WIRES prior to disconnection when 

servicing controls.  Wiring errors can cause 

improper and dangerous operation

FAILURE TO MAINTAIN THE BOILER in proper 

working condition may lead to fire, explosion, 

personal injury or death, and extensive property 

damage.

TURN OFF ALL GAS AND ELECTRIC power 

supplies to the boiler before servicing. Contact with 

or release of dangerous flammable gas, electrical 

voltage, moving parts, and very hot water under 

pressure may cause serious personal injury, 

property damage, or death. 

LOCK ELECTRICAL BOXES AND GAS VALVES 

CLOSED to prevent someone from inadvertently 

restoring power or gas before the heating system is 

safe to operate.

Equipment you will need:
q

   Soft bristle brush

q

   Bristle flue brush

q

   Vacuum with brush attachment

Perform these tasks each year:

  Clean low water cutoff probe (if applicable).

  Inspect vent for obstruction and signs of 

condensation, distortion, overheating or gas 

leakage.

  Clean vent terminal and air intake screens.

  Inspect boiler flue passages:

(1)   Remove vent pipe, damper.
(2)  Remove top panel and hood.
(3)   Remove blocked vent switch and   

  canopy. 

(4)   Examine all flue passageways.  Using  

  bristle flue brush and vacuum,    

  remove any soot or obstructions.

.  Remove and clean main burners:

(1)

   Remove jacket front panel.

(2)

   Disconnect pilot tubing at gas valve.

(3)

   Disconnect pilot lead wires at gas valve.

(4)

  Remove wires from flame roll-out switch.

(5)

   Remove burner access panel.

(6) 

  Mark location of the pilot main burner on  

       the manifold if the marking on manifold   
       is missing or obliterated.

AM-1

(7)

   Hold burner at throat.  Lift front of burner 

       to clear orifice (Figure AM-1). The  

   burner that holds the pilot can only be 

     removed by first lifting the burner  

   adjacent to its right.

  Perform Startup Checks and Adjustments 

described earlier in this manual.

  Check operation of airflow sensing switches.

  Check for water leaks on the boiler or water 

pooling around boiler.

  Manually operate the relief valve.  If the 

water is grey or black, there is excessive 

oxygen in the system.  Oxygen is corrosive 

to boilers.  Eliminate any source of oxygen.

 Verify proper operation after servicing.