Руководство По Работе для Sony RM-VLZ620

RM-VLZ620_U (US) 4-170-639-12(1)

The RM-VLZ620 failed 

to learn the signals of 

the remote control 

supplied with the device.

 Avoid learning in places under direct sunlight or strong 

fluorescent light.

 Turn off any nearby infrared devices, such as an air-conditioner 

or headphones.

 Avoid learning near a plasma TV, or turn off the plasma TV 

while learning.

 When teaching the signals, keep the distance between the RM-

VLZ620 and the other remote control about 3 – 8 cm (1 – 3 

in.).

 The RM-VLZ620 supports infrared signals only. RF signals or 

two-way communication signals are not supported.

 The batteries are weak. Use new batteries in both remote 

control units.

You cannot operate the 

device even after 

teaching the 

RM-VLZ620.

 Make sure that you teach the RM-VLZ620 the correct signals 

(page 20). 

 The volume, cursor, and some other buttons continue to work 

when pressed down for some seconds. If you teach the signals 

of such buttons, the RM-VLZ620 may not learn the signals 

accurately. Teach the signal by holding down the button on the 

remote control of the other device. 

 The consecutive procedure has been already programmed on 

the button. Clear the program (page 30).

 There are no available buttons for teaching. Clear the 

infrequently used learned functions (page 23), and teach the 

signals again.

After programming the 

power-on signal of the 

device, pressing that 

Device Select button 

does not function 

correctly.

 You have already set a new function or consecutive procedure 

on the Device Select button. Clear the learned function or 

programmed procedure. 

This function is for Sony devices only.

A consecutive 

procedure does not 

work properly.

 When you program a consecutive procedure, make sure to 

follow the correct steps (pages 28).

 Change the direction the RM-VLZ620 is aimed. If the problem 

persists, position the programmed devices closer together.    

 Remove any obstacles in the path between the RM-VLZ620 

and the devices.

 Position the devices back to the way they were before you set a 

consecutive procedure.

 Some devices may not always be powered on by a consecutive 

procedure. This is because the power of the device turns on 

and off alternately when receiving the power on/off signal. In 

this case, check the operating device’s power on/off status 

beforehand.

 If you change the manufacturer’s code or teach a new signal on 

a button that has been programmed for a consecutive 

procedure, the new signal will be transmitted when you press 

the corresponding Device Select button.

 Some devices may not respond to the next signal immediately 

after the power-on signal.  

In this case, you can insert an interval by the following means.

  –  Change the button order.

  –  Press the same Device Select button again. Each time you 

press the button, you can insert an interval (page 30).

 The button has already learned a function. Clear the learned 

function (page 23).

 Check the status of the device and make sure that you have set 

the device properly to receive signals.

After you have read through this manual, if you still cannot get the RM-VLZ620 to work 

properly, call the Sony Customer Support Helpline  

at 1-800-822-2217.