Справочник Пользователя для Tektronix Camcorder 2200
2-46
Section 2— Control Panel Descriptions
TRAN RATE
is used with the keypad to set the rate used by the
AUTO TRANs
(auto transition) button in the transition areas and by
the
EFFect DIS
button on the E-MEM keypad.
When
TRAN RATE
is pressed, the E-MEM display queries:
SET WHICH RATE?
and any Enable buttons that are on turn off.
The transition rate is then delegated to the desired Transition
Subpanel by pressing
Subpanel by pressing
M/E 1
or
M/E 2
. Both of these functions may
be enabled simultaneously by pressing
ENABLe ALL
.
After enabling the desired levels, the display queries:
AUTO RATE = ?
Enter the desired rate using the numeric buttons on the keypad.
Entering three digits on the keypad automatically enters the rate.
If only one or two digits are entered, the entry must be completed
by pressing
Entering three digits on the keypad automatically enters the rate.
If only one or two digits are entered, the entry must be completed
by pressing
ENTER
. Rates from zero through 999 frames may be
entered. If one or two digits have been entered, the entry may be
cleared and the previous rate restored by pressing
cleared and the previous rate restored by pressing
TRAN RATE
again. As soon as the new rate is confirmed, it is displayed in the
auto transition rate display in the delegated transition
subpanel(s).
auto transition rate display in the delegated transition
subpanel(s).
When the transition rate has been set, the
TRAN RATE
button turns
off and the Enable buttons return to their previous state, as does
the keypad readout display.
the keypad readout display.
Tran
Rate
Rate