Справочник Пользователя для McDATA ULTRANETTM EDGE STORAGE ROUTER 3000

 

7. Issue the 

 command at the FTP prompt.

Use the following procedure to install the new UltraNet Edge 3000 
software:

1. Issue an 

upgrade EDR31xx.tar 

command to install the new 

software. 

Where xx = the most current version of the UltraNet Edge 3000 
software.

This can take up to 45 minutes. Wait for the system prompt to come 

back after issuing the upgrade command. If the process is interrupted, the 
UltraNet Edge 3000 could hang.

2. Issue the 

 command. This will boot up the UltraNet Edge 

3000 and invoke the new software.

3. Immediately telnet to the UltraNet Edge 3000 that has just been 

upgraded.

You will be prompted for a login and password. The login is root 
and the password is what has been defined for the node. The 
prom default password is shadow.

4. Press 

 to get into prom mode.

5. Issue the 

 command to display a listing of 

the files within the tar archive file you wish to extract.

6. Check the resulting list to see if any of the files within the tar 

archive already exist on the disk. If versions of the files within the 
tar archive already exist on the disk, check their size to see if they 
are larger than the versions in the tar archive.

7. If any files in the tar archive are larger than the corresponding 

files on the disk, proceed to step . If the files in the tar archive are 
smaller

 than the corresponding files on the disk, do one of the 

following:

— Rename the corresponding file(s) on the disk using the 

 command.

— Remove the corresponding file(s) on the disk using the 

 command.

8. Issue the 

command at the prom 

prompt. This will take from one to three minutes, wait for the 
prom prompt to return before proceeding to step .