Инструкции По Установке для Whirlpool WET4027EW

Drain System

Drain system can be installed using a floor drain, wall standpipe,  

floor standpipe, or laundry tub. Select method you need.

Minimum diameter for a standpipe drain: 2" (51 mm). Minimum 

carry-away capacity: 17 gal. (64 L) per minute. Top of standpipe 

must be at least 39" (991 mm) high; install no higher than 96"  

(2.4 m) from bottom of washer/dryer. If you must install higher 

than 96" (2.4 m), you will need a sump pump system.

See requirements for floor standpipe drain system.

Floor drain system requires a Siphon Break Kit (Part Number 

285834), 2 Connector Kits (Part Number 285385), and an  

Extension Drain Hose (Part Number 285863) that may be  

purchased separately. To order, please see toll-free phone  

numbers in your Use and Care Guide. Minimum siphon break: 

28" (710 mm) from bottom of washer/dryer. (Additional hoses 

may be needed.)

Minimum capacity: 20 gal. (76 L). Top of laundry tub must be  

at least 39" (991 mm) above floor on 27" models, or 34" (864 mm)

above floor on 24” models; install no higher than 96" (2.4 m) from 

bottom of washer/dryer. 
IMPORTANT: To avoid siphoning, no more than 4.5" (114 mm) 

of drain hose should be inside standpipe or below the top of 

wash tub. Secure drain hose with shipping strap or plastic strap.