Справочник Пользователя для Amana NED4655EW

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

       Not Level 

            

LEVEL                    Not Level

NOTE: The dryer must be level for the moisture sensing system 

to operate correctly.

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. 

Once legs are level, make sure all four legs are snug against 

the ground before tightening them.

Move dryer to final location.  Avoid crushing or kinking vent. 

After dryer is in place, remove corner posts and cardboard 

from under the dryer.

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  For power supply cord installation, plug into an outlet.  

For direct wire installation, turn on power.

q

  Check that dryer is level. See “Level Dryer”.

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide”.

q

  Set the dryer on a full heat cycle (not an air cycle) for  

20 minutes and start the dryer.

 

■

Controls are set in a running or “On” position.

 

■

Start button has been pushed firmly.

 

■

Dryer is plugged into an outlet and/or electrical supply  

is on.

 

■

Household fuse is intact and tight, or circuit breaker has 

not tripped.

 

■

Dryer door is closed.

Check levelness of dryer from side to side. Repeat from  

front to back.