Инструкции Пользователя для Asko T884XLHPW

20

Customer Care Center, 1-800-898-1879, www.askona.com

INSTALLATION

Read the Electrical requirements and grounding 

instructions before connecting the tumble dryer.

Electric models of the dryer are manufactured for a
3-wire connection system. The dryer frame is grounded 

by a link to the neutral conductor on the dryer terminal 

block. If local codes do not permit grounding through the 

neutral, the grounding link from the terminal block must 

be removed and a separate ground wire must be used.
Only a 4-conductor cord shall be used when the 

appliance is installed in a location where grounding 

through the neutral conductor is prohibited. Grounding 

through the neutral conductor is prohibited for new 

branch-circuit installations, mobile homes, recreational 

vehicles, and areas where local codes prohibit grounding 

through the neutral conductors. The grounding link on the 

dryer must be removed for all 4-wire installations.
These Electrical Connection instructions provide for 

installing the dryer in the following situations:
3-wire connection where local codes permit grounding 

through the neutral. 3-wire connection plus separate 

grounding connector where local codes do not permit 

grounding through the neutral.
4-wire connection.
Each of the above connections can be made with an 

approved power supply cord or by direct wiring. Each 

connection instruction identifies the appropriate Power 

Supply Cord and covers requirements for direct wiring.

NOTE!
In Canada, the dryer is delivered ready-fitted with a 

four-prong plug intended for connection to a single-

phase supply.

Before starting this procedure, be sure the power is 

turned off at the breaker/fuse box.

You will need a 3-wire power supply cord with three No. 

10 copper wires and a matching 3-wire receptacle of 

NEMA Type 10-30R, as illustrated below:
To connect a 3-wire power cord to the dryer, follow the 

steps below.

NOTE!
The numbers in the illustration correlate to the step 

numbers.

1.  Turn the power off at the breaker or fuse box.
2.  Remove terminal block cover.
3.  Use the strain relief attached below the terminal block 

opening.

4.  Loosen or remove center terminal block screw.

4

5

6

5.  Connect ground (center) wire of power supply cord 

to the center, silver-colored terminal screw. Tighten 

screw.

6.  Connect the other wires to outer screws.
7.  Tighten the strain relief screws.
8.  Replace terminal box cover on back of dryer.