Инструкции Пользователя для Asko T884XLHPW
21
Customer Care Center, 1-800-898-1879, www.askona.com
INSTALLATION
9. Plug dryer into wall receptacle.
10. Turn power on at breaker/fuse box.
10. Turn power on at breaker/fuse box.
Connecting a 4-wire Power Cord
WARNING !
Before starting this procedure, be sure the power is
turned off at the breaker/fuse box.
Power Supply Cord
You will need a 4-wire power supply cord with four No. 10
copper wires and a matching 4-wire receptacle of NEMA
Type 14-30R, as illustrated below.
The fourth wire must be identified with a white cover and
The fourth wire must be identified with a white cover and
the ground conductor by a green cover.
To connect a 4-wire power cord to the dryer, follow the
To connect a 4-wire power cord to the dryer, follow the
steps below.
NOTE!
The numbers in the illustration correlate to the step
The numbers in the illustration correlate to the step
numbers.
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal block
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal block
opening.
4. Remove center terminal block screw.
6
4
7
8
5. Remove ground wire (green with yellow stripes) from
external ground connector screw and remove from
center terminal block.
6. Connect ground (green) wire of cord to external
ground conductor screw.
7. Connect neutral (white) wire of cord under center
screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10. Replace terminal box cover on back of dryer.
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.
9. Tighten the strain relief screws.
10. Replace terminal box cover on back of dryer.
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.